Wuhan GDZX Power Equipment Co., Ltd
Add to Cart
ZX-HM Insulator Non-soluble deposit density Tester
● Adjustable air inlet to control the temperature and gas discharge in the box.
● The measurement can choose multiple modes.
● The blast drying adopts German technology and advanced air duct; the fan has low noise and stable performance.
This is a complete set of measuring equipment, which contains electronic balance, air blast drying device, vacuum filtration device, and accessories. The whole set of device is simple and accurate.
1. The vacuum filtering device has the advantages of mature technology, convenient use and high efficiency. It contains a number of taps, can realize a number of filtering process. The use of water circulation device to replace the oil circulation pump make it more convenient with low failure rate
2. The air blast drying device adopts German technology, the air duct is advanced, the fan noise is small, the performance is stable;
3. Microcomputer High precision intelligent control. Once set the temperature, it self judge the heating power and display heating state.
4. Adjustable air inlet for temperature control and gas emissions.
5. digital electronic balance has correction function, self-checking function, and multiple modes.
| Balance precision | 0.1mg |
| Maximum weighing | 200g |
| Temperature range | room temperature +10℃～250℃ |
| Temperature resolution | 1℃ |
| Temperature fluctuation degree | ±1℃ |
| Temperature uniformity | ±1℃ |
| Filtration flow | L/Min:60 |
| The maximum degree of vacuum filtration | MPa:0.098 |
| Single head exhaust air filtration | L/min:10 |
| The number of air filtration head | 2 pcs |
| Supply voltage | 220±10% |
| Ambient temperature | 5-40℃ |
| Relative humidity | 85% |
ZX-HM Insulator Non-soluble deposit density Tester
ABOUT US
Transportation
5. The selected connection method of the instrument should be consistent with the actual connection of the transformer.
6. The low-voltage short-circuit wire should be firmly short-circuited, and the short-circuit wire should not be less than 25mm2.
7. Do not allow the instrument to work beyond the measurement range.